I am using a run macro action to create a new tab, and then populate a URL for a screen pop. The product is called Numara Footprints, and it runs in a browser. It is working fine, but the issue I am having is that it opens the new tab in whatever IE browser is active at the time, even though I am calling the correct window by name at the beginning of the workflow. Has anyone seen this before? Here is the beginning of the workfow;
[APPLICATION:IEFRAME=FOOTPRINTS - PRE-PRODUCTION - WINDOWS INTERNET EXPLORER] [DELAY] 2000 [CONTROL] T [DELAY] 2000
Thanks for your response Geoff. The IE version is 8.0. So, this is normal for IE and not a bug?
I originally got this working with an http workflow in the embedded browser, it worked great ... fast and clean. But they thought it was confusing to have the main page outside the browser and the pop within. So I have the screen pop wuery URL hard coded in a couple of PV's, and I just add the variable with the ticket number after. I was actually surprised that worked, but it did. It is too bad you cannot use the http workflow step outside of CAD. That would have made everything really easy for me.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...