I'm trying to figure out what is the best way to schedule multi skilled agents in WFM based on the scenario below.
1.There are 3 CSQs (Eng, Man, Jpn)
2.There are groups of agents who (skill based routing)
a.Can only handle a single CSQ
b.Can handle 2 CSQs. For example, Priority 1 for Eng, P2 for Man OR P1 Man, P2 Eng OR P1 Eng P2 Jpn OR P1 Jpn P2 Eng
c.Can handle all 3 CSQs where the priority could vary. For example, P1 Eng P2 Man P3 Jpn OR P1 Man P2 Jpn P3 Eng & so on.
3.The multi skilled example shown in admin guide only shows the multi skill agents as having equal priority for each of their skills. In the scenario above, agents with multiple skills are having different priority for each skill.
Is this achievable by the items below or there's other way to do so
1.Having 3 CSQs in WFM
2.Having 1 skill group mapping for each combination of skill(s). For example 1 each for Eng, Man & Jpn; 1 each for P1 Eng P2 Man, P1 Man P2 Eng and so on.
3.Higher priority given to skill group mapping with the least skill. For example, higher priority for Eng only, Man only and Jpn only skill group
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...