You could throw in an IF node that checks for the date 12/24/08. Then for the success leg of the IF node have it route to the different hours you will have for Christmas Eve. Then you dont have to worry about going back and correcting the hours later on. Hope this helps.
We have built into all of our scripts a "Manually Open" or "Manually Closed" state check. So you can setup an XML Document with Close, Open, etc. and when the script starts, it checks to see if yoru manually closed. Then the supervisor of that particular Q/Script calls into an auto attendant and can set the state of the system from any touch tone phone. If you want the script examples I can send them to you. email@example.com
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...