Send2VRU gets aborted while placing a csim call. Problem is while executing bootstrap, handoff is not being done. Also find below the output of "debug voip application script". Its CVP comprehensive with SIP protocol. Type 10 VRU has been configured.
Do a "show call application voice new-call". You need to see a State = Registered. If not, then you either do not have the new-call service defined properly or the bootstrap.vxml file does not exist in flash:
I need to back rbua on this. A few weeks ago I troubleshot a QSIG trunk problem with CSIM start for hours. To come to finally build the rest of the CCM and figure out it was working properly from the word go. CSIM start should never be used for actual testing!!
yeah IOS csim is kind of strange. it has not been working for me lately either. For the CVP csim tool though, its only in 7.0(1) version and you have to open a command prompt to run it. it uses the same commands. you can type "csim help" and see more info.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4