cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
312
Views
0
Helpful
1
Replies

Set CallingNumber from Script when forwarding call

walteryork
Level 1
Level 1

I would like to define the "calling number" when forwarding calls to an outside line. I know I could mask the number through the Call Manager but that would not allow me to change the number based on each script I am using.

1 Accepted Solution

Accepted Solutions

Chris Deren
Hall of Fame
Hall of Fame

The only solution I can think of is doing this at the cti port level, where you'll configure seperate jatpi groups for each application thus a script. Then configure the external phone number mask on the cti ports to the appropriate one.

HTH, please rate all helpful posts!

Chris

View solution in original post

1 Reply 1

Chris Deren
Hall of Fame
Hall of Fame

The only solution I can think of is doing this at the cti port level, where you'll configure seperate jatpi groups for each application thus a script. Then configure the external phone number mask on the cti ports to the appropriate one.

HTH, please rate all helpful posts!

Chris

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: