Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Set CallingNumber from Script when forwarding call

I would like to define the "calling number" when forwarding calls to an outside line. I know I could mask the number through the Call Manager but that would not allow me to change the number based on each script I am using.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Set CallingNumber from Script when forwarding call

The only solution I can think of is doing this at the cti port level, where you'll configure seperate jatpi groups for each application thus a script. Then configure the external phone number mask on the cti ports to the appropriate one.

HTH, please rate all helpful posts!

Chris

1 REPLY
Hall of Fame Super Silver

Re: Set CallingNumber from Script when forwarding call

The only solution I can think of is doing this at the cti port level, where you'll configure seperate jatpi groups for each application thus a script. Then configure the external phone number mask on the cti ports to the appropriate one.

HTH, please rate all helpful posts!

Chris

113
Views
0
Helpful
1
Replies
CreatePlease login to create content