Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Silent Monitoring not work

Dear All,

I am currently using UCCX4.5 Enhanced Edition which should have Silent Monitoring function. I have enable "SPAN to PC" function in CUCM and the agent desktop is directly connected to agent phone. Supervisor Desktop and Agent Desktop are on the same VLAN. VoIP Monitoring service in UCCX is enabled. But I can not hear the voice after I press monitoring buttom. Anyone know what's the problem?

Thanks!

Best Regards,
Teru Lei

3 REPLIES

Re: Silent Monitoring not work

Hello Teru,

Please use the follow document to check that everything is well setup in the UCCX, in that everything is well configure please reset the "VoIP monitor Service"

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps556/products_tech_note09186a00801a62a8.shtml

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Re: Silent Monitoring not work

First thing you need to do is install Wireshark on agent PC. Agent login to IP Phone that directly connect to agent.

Make a call, then open wireshark. If you can see a lot of RTP packet coming, so that is ok with Span to PC option enable and your network card can detect tagging packet.

After sucessful to see RTP packet, you need to check following step:

1. the codec for the call must be G711, not G722 at default of Cisco.

2. All firewall are turned off (include windows firewall and some built in firewall come with antivirus software)

3. Make sure supervisor PC has a sound card (of course)

4. Enjoy!

New Member

Re: Silent Monitoring not work

Hi Doan,

Thanks and I will try it.

Best Regards,

Teru Lei

375
Views
0
Helpful
3
Replies
CreatePlease to create content