Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Single Route Point with Multiple DNs on UCCE

Hi Guys,

I had this question from one of our IP Tel Engineers. The reason being it's quicker for him to create 1 Route Point and then create multiple lines(DN) for that RP.

However, I have never done this before and not sure if it's going to work or if it's even supported.

Has anybody done this before? If yes, what's the difference and what's the benefit of doing it this way.

Thanks

Erwin

2 REPLIES
Green

Re: Single Route Point with Multiple DNs on UCCE

When the BAT files are set up, adding lots of route points is not a big deal. How many are you requiring? They have to be associated with JTAPI but this is a 1 minute job.

Regards,

Geoff

New Member

Re: Single Route Point with Multiple DNs on UCCE

Hi Geoff,

Unfortunately the CM is version 5.1 so I don't think you can add the RP using the BAT.

I agree with you that it's not a big deal but the question came up because I heard someone has done it before and it works.

So I wanted to see if anyone else has done it as well or if this is supported.

Regards

Erwin

131
Views
0
Helpful
2
Replies