Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Slow Agent Application log on

We upgraded to UCCX 8.5.1.10000-37 and installed 8.5 Agents.

When anyone attempts to log into the Agent application, it hits "Initializing Agent Monitoring" and sits there for a full 3 minutes.  We see it on all our agents (not many - under 10) and it's operating system independent (Win 7 vs XP, same thing).  We check DNS set up (all correct).  Any ideas where to look?

1 ACCEPTED SOLUTION

Accepted Solutions

Slow Agent Application log on

Hi Kirstein,

Please access the UCCX serviceability page and see if the Agent Monitoring service is up and running. Also on the right hand bottom side of the CAD Agent window do you see the Partial service section, if yes click on it and see what is the service which is in partial state.

Is this a UCCX high availability setup? Are all the service master ship is owned by UCCX node1 (Publisher) if not please restart the Second node so that all the services master ship is owned by Node1 and then check the behaviour.

Also please try adding the entry for  hostname of the UCCX on the CAD client boxes and check.

And one more thing, why don’t you upgrade it to UCCX 8.5 SU2 because many of the CAD issues have been witnessed in the base build which were resolved in SU2.

Hope it helps.

Anand

Please rate helpful posts!!

2 REPLIES

Slow Agent Application log on

Hi Kirstein,

Please access the UCCX serviceability page and see if the Agent Monitoring service is up and running. Also on the right hand bottom side of the CAD Agent window do you see the Partial service section, if yes click on it and see what is the service which is in partial state.

Is this a UCCX high availability setup? Are all the service master ship is owned by UCCX node1 (Publisher) if not please restart the Second node so that all the services master ship is owned by Node1 and then check the behaviour.

Also please try adding the entry for  hostname of the UCCX on the CAD client boxes and check.

And one more thing, why don’t you upgrade it to UCCX 8.5 SU2 because many of the CAD issues have been witnessed in the base build which were resolved in SU2.

Hope it helps.

Anand

Please rate helpful posts!!

Community Member

Slow Agent Application log on

Thank you Anand.  I was the UCCX Agent Monitoring that was not up and running.  We got it started and login is now very fast. 

1211
Views
0
Helpful
2
Replies
CreatePlease to create content