Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TDM switching with 3845

Dear all,

I have a 3845. In slot 1 and 2, I have a Voice VM-8FXS/DID Port adapter with two NT or TE BRI Voice Expansion Module (4 port). 2 E1 (2 port) Multi-Flex Trunk WAN daughter card in slot 0 are used to connect to the PSTN.

I was able to enter the following commands:

network-clock-participate slot 1

network-clock-participate wic 0

network-clock-participate wic 1

network-clock-select 1 E1 0/0/0

network-clock-select 2 E1 0/0/1

But this one doesn't work:

# network-clock-participate slot 2

Slot is empty or does not support clock participate

Any ideas ?

The hardware of slot 1 is the same than

slot 2.

Many thanks

Phil

1 REPLY
Silver

Re: TDM switching with 3845

Firrst try , no network-clock-participate slot 1, no network-clock-participate wic 0, no network-clock-participate wic 1

then try

network-clock-participate slot 1

network-clock-participate wic 0

network-clock-participate wic 1

Remove the following commands:

network-clock-select 1 E1 0/0/0

network-clock-select 2 E1 0/0/1

253
Views
0
Helpful
1
Replies