Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

The time showing on Cisco Unified CCX Historical Reportsare not correct

Hello,

Issue: The time showing on the Historical Reports are not correct

Error message/issue description:

While  comparing the recorded calls from QM Management Destop system to the reporting system the timings on the historical reports appear to be at least an hour behind. Can these be synced to show the same times

Thanks !!
Shridhar Reddy

1 REPLY

The time showing on Cisco Unified CCX Historical Reportsare not

Hi Shridhar,

The  time zone displayed in the report is either UTC or local time zone,  based on the TIMEZONE settings in hrcconfig.ini. You can also change the  time zone for each report as shown in the procedure.

Note:  When a report shows date and time information for an event or an  activity in the report data, that date and time is based on the TIMEZONE  configuration in hrcconfig.ini.

The Start and End time is also based on the TIMEZONE configuration in hrcconfig.ini.

The difference between the server time and the selected time zone is displayed within parentheses beside the Start and End time.

The report generated time displayed at the bottom of the report is the local time of the HR client machine.

To change the time zone for a particular report, follow these steps:

Procedure:

Step 1: In the Unified CCX Historical Reports main window, choose the report settings that you want.

Step 2: Choose the Settings menu.

Note:  You notice the check mark beside the Use UTC Time Zone for Reports menu  option. This depends on the configuration in hrcconfig.ini.

If  UTC time zone (value 1) is configured, the check mark is displayed. If  local time zone (value 0 - Default) is configured, the check mark is not  displayed. For more details, refer The hrcConfig.ini Configuration  File, page 2-13.

Step 3Click Use UTC Time Zone for Reports to select or unselect the option manually.

Please refer the section "The hrcConfig.ini Configuration File" from page 33 onwards in the below link,

http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_8_5/user/guide/uccx85hrug.pdf

Also please refer the below thread for changing time zone.

https://supportforums.cisco.com/thread/2145833?tstart=0

Hope it helps.

Anand

Pls rate helpful posts !!

429
Views
0
Helpful
1
Replies