Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

Timer Action - CAD - Outbound scenario


We are trying to use a "Timer Action" in a particular workflow created in the CAD Administrator.

we need need to force "Not Ready" state when the contact call is dropped, wait for 20 seconds and then when the timer expire make "Available" the agent again, we are trying to make a "wrap up" time. We are using a unique agent desk setting.

When we try to implement this in an outbound scenario using Outbound dialer, we can force the first agent state to "Not Ready", but the timer action never applies. When the timer expires the agent never backs to the "Available" state.

We are using "Preview" as dialing mode for the campaign.

Somebody knows what's wrong?

Maybe we can't use timer action in order to force an agent state when outbound dialer is been used in "Preview" mode?

Thanks in advance


Re: Timer Action - CAD - Outbound scenario

Do not close the CAD-BE window without first logging out. If you do, you will remain logged in to the ACD for 20 minutes, at which

time you will be automatically logged out.

You must be in the Not Ready state to make a call. The Make Call button is disabled

when you are in the Ready state.

CreatePlease to create content