Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trouble adding new JTAPI trigger

When I attempt to add a new JTAPI trigger to an application, I'm getting an error just below the Directory Number textbox:

* Could not update the user on the CallManager.

I am unable to figure out the cause. Any help on this would be greatly appreciated.

IPCC Express Enhanced

4.0(4)_Build140

Call Manager

4.2

2 REPLIES
Bronze

Re: Trouble adding new JTAPI trigger

Could you pls confirm that Jtapi Trigger does not exist in CCM.

New Member

Re: Trouble adding new JTAPI trigger

Yes, I confirmed that it does not exist. Thanks.

I found a solution after some more extensive searching on these forums.

Basically, it was suggested that I:

-clear up any CRS->CM synchronization issues,

-make sure the CRS was in full service,

-try again

After removing an older not used trigger that was out of sync with call manager and resynchronizing, I was able to add the new trigger without error.

153
Views
0
Helpful
2
Replies
CreatePlease to create content