Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCCE CAD reporting an agent extension is a shared line when it is not

I have this issue pop up every once in while when my helpdesk people will create a UDP and add an agent's extension to the profile.  I will remove the extension but when attempting to log in via CAD it reports that the extension is a shared line.  Anyone know what I have to do to get this to go away?

 

Thanks in advance

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

If you run a Route Plan

If you run a Route Plan Report in CUCM for that specific extension, does it show more than one device?

Please rate helpful posts
Thanks,
Tony
4 REPLIES
Silver

If you run a Route Plan

If you run a Route Plan Report in CUCM for that specific extension, does it show more than one device?

Please rate helpful posts
Thanks,
Tony
New Member

Probably assigned IPT and CTI

Probably assigned IPT and CTI. We had a huge problem with that this past winter. 

New Member

No sir, this was not the case

No sir, this was not the case.  All extensions are on only one device. 

New Member

I have run the report.  To

I have run the report.  To clarify, these extension were once shared (UDP, CIPC...) but I've removed all of those associations to no avail. 

202
Views
0
Helpful
4
Replies
CreatePlease login to create content