UCCE Supervisor workflow stop when switching between Side A and B
I am running onto a strange issue with UCCE 7.5. When we switch from Side A to B and then back to A the supervisor workflows stop functioning. When I reset PGA and everybody goes to PGB some of the workflows start working intermittently. If I then reset PGB so that PGA is the active one again everything starts working normal.
I tried to look for the configuration files of the workflows but I am unable to find them - I guess they should be on the PGs? I was looking for something called SWF... or is it in the LDAP that is on the Agent PG?
However, do you know if this is some kind of bug or probably is a sign of misconfiguration?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.