Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCCX 5.X: how to assign different "reason code" to different queues

can someone please advise how to assign different "reason code" to different queues in UCCX 5.x? or is it just a universal/global function?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: UCCX 5.X: how to assign different "reason code" to different

Hi

In CCX 5.0 or below, Not Ready, Logoff, and Wrap codes are all global.

In CCX7.0, you can set up global codes, and then assign these codes seperately to different workflow groups via Desktop Administrator.

You can't assign them to seperate CSQs directly, but if your agents are split into suitable workflow groups that mirror your CSQs, then you have a similar effect.

I.e. if you have a Service Desk CSQ, and a Customer Service CSQ, and these are serviced by different agents... then you can assign CS agents to a CS workflow with specific reason codes assigned, and do the same fo rthe Service Desk agents. If your agents are multi-skilled (i.e. take calls for both flows) then your only option is to train the agents to set the right codes, or name the codes with a prefix for the CSQ to make it easier for them to pick them.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
2 REPLIES
Super Bronze

Re: UCCX 5.X: how to assign different "reason code" to different

Hi

In CCX 5.0 or below, Not Ready, Logoff, and Wrap codes are all global.

In CCX7.0, you can set up global codes, and then assign these codes seperately to different workflow groups via Desktop Administrator.

You can't assign them to seperate CSQs directly, but if your agents are split into suitable workflow groups that mirror your CSQs, then you have a similar effect.

I.e. if you have a Service Desk CSQ, and a Customer Service CSQ, and these are serviced by different agents... then you can assign CS agents to a CS workflow with specific reason codes assigned, and do the same fo rthe Service Desk agents. If your agents are multi-skilled (i.e. take calls for both flows) then your only option is to train the agents to set the right codes, or name the codes with a prefix for the CSQ to make it easier for them to pick them.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: UCCX 5.X: how to assign different "reason code" to different

Thanks Aaron for detailed explanation. much appreciated!

Aamir

964
Views
0
Helpful
2
Replies