Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCCX 7.0 - Call priority routing based on skill

Howdy,

I'm not sure of the best way to go about this. I have one main queue (CSQ A) and an escalation queue (CSQ B). Tier 2 CSRs will be assigned both the CSQ A skill and CSQ B skills so that they can answer normal calls when CSQ B is empty.

The tricky part is CSQ B is not meant to be reached by outside callers and it's not referenced in the CSQ A script. The only way to get placed in that queue is when a CSR transfers to it.

Is there a way to set this up so that CSQ B calls take priority for Tier 2 CSRs over CSQ A calls?

Any help would be much appreciated.

Cheers,

Gary

1 REPLY
Super Bronze

Re: UCCX 7.0 - Call priority routing based on skill

Hi

You can't issue a higher priority to a CSQ as such, but yu can use the 'Set Priority' step to increase the priority of calls in your script just before the 'Select from CSQ B' step.

Basically a call with default priority will be serviced FIFO with other calls. If you make any call +1 higher priority, it will be answered before any default priority calls. Calls from each priority will be answered before calls from a lower priority.

Regards

Aaron


Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
1041
Views
5
Helpful
1
Replies