The version of Call Manager that I am on does not have a way to block an ANI coming into system (apparently later release do, will upgrade later).
The calls from these auto-dialers that are coming in are going to our Call Center Express trigger.
I created translation pattern that directs calls to that trigger to a new script. New script has "if/ then' stmt that says if the nubmer is xxx-xxx-xxxx (listing the specific auto dialer number), I route it to a fax machine, if not then go to next step, did another 'if / then' for the 2nd auto dialer number, if not that number then I route the call to the regular trigger for the call center script (if it is then it also goes to the fax number).\
That works , there is some delay though.
Those auto dialer calls have not stopped (number of calls reduced signficantly- but not gone).
Now I need to add another number that is auto dialing us ... I am thinking initial delay is going to get longer ......
could not figure out how to list more than on ANI ... seems I had to do a new "if/ then" statement for each number ..........
Any ideas on improving the script to be more efficient?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.