Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCCX 7.0 script debug

I am getting the following error when I do a debug on a script, the script was working before and now just stopped.  Task:18000000007 AcceptStep: Trigger is not a ContactApplicationTrigger"  Has anyone seen this and could you provide any insite?

Thanks

1 REPLY
VIP Super Bronze

Re: UCCX 7.0 script debug

This is caused by attempting to execute a step that requires an active contact (e.g. accept, play prompt, select resource, etc). If you are stepping through the script there is no active contact. You can either add code to skip past these steps; or, load the script to an application and perform a reactive debug instead.

Please remember to rate helpful responses and identify helpful or
1037
Views
0
Helpful
1
Replies