06-19-2012 06:29 AM - edited 03-14-2019 10:04 AM
Hi,
I am in the process of going through a new UCCX fresh installation and when I try to run the CAD Client Configuration.msi it is showing the following error:
Error opening DB: error = d<110>
Anyone seen this one before?
Thanks
Carl
06-20-2012 01:40 AM
Just to let you know, this error is related to running the CAD Client Configuration on a Windows 7 64 bit machine. Run it on WinXP and it went through no problems.
Thanks
Carl
11-06-2014 03:07 AM
Just to add an info to Carl statement, you just need to do this operation once, so using XP, and then you can use CAD on 7 64 bits. Also I suggest to consider to use Finesse, since CAD is going to be dismissed.
Regards
Domenico
07-02-2012 02:42 AM
Hi have same problem when i install CAD Client Configuration. I am using Windows 7 Ent. x64. Carl Messer
recommend using windows xp. But many people are now using windows 7 x64. It can be solution this issue cisco dev. site.
05-17-2013 10:17 AM
I have the same issue with 9.0.1 version running on Windows 7 x64.
Has someone solved it?
Thanks
Domenico
07-01-2013 08:25 AM
The problem is Windows 7 64-bit.
Run the config utility in XP Mode and it works fine.
11-05-2014 06:56 PM
I could not get it to run even using "Compatibility Mode" on Windows 7 64-bit. Ran it on Windows Server 2008 R2 64-bit and it ran fine
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: