I have a CCX 9.1 new install. Everything seems to be working correctly except for the Trigger creation. I have tried multiple systems and browsers. When I create the Trigger, it will correctly build the CTI and DN in CCM, but the actual window I created the Trigger in goes white and I get no further feed back from it. The Triggers do not show in the Trigger list as created either. Any ideas? Thanks. - JR
Try creating a new trigger with a very short name with no special characters. I have seen this issue where UCCX didn't prompt an error when I put in an invalid name, but it would hang similar to the way you are describing. Go really basic with the new trigger just to make sure you can build something that shows up in both places.
If that doesn't work, try another browser. It has fixed more than one issue I have had with wonky webpages.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...