02-29-2012 06:29 AM - edited 03-14-2019 09:27 AM
I want to know if UCCX (VERSION 5+) support SNMPv3 and where is the supported documentation... thanks in advance...
02-29-2012 06:41 AM
Hi,
I checked the UCCX 8.0 guide (link given below), please refer from page 94 onwards,
It states,
The system provides no default SNMP configuration. You must configure SNMP settings after installation to access MIB information. Cisco supports SNMP V1, V2c, and V3 versions.
Thanks,
Anand
02-29-2012 09:42 AM
Does anyone know for the previous UCCX version (version 7as an example)... Is there any way to support SNMPv3 with these older version ?
02-29-2012 10:36 PM
HI,
Please refer the section "Simple Network Management Protocol Support" from page 23 onwards, I did not see any refernces wrt to SNMPv3,
Thanks,
Anand
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide