Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

UCCX Application Tasks not terminating

I obviously have a problem with one of my UCCX applications/scripts where it is not clearing out and is taking up resources.  See the attached screenshot of the "Application Tasks" real time report.  Some show they have been running for over 50 hours.  Does anyone know if there is a way to clear these out without having to restart servers and/or services?                  

1 ACCEPTED SOLUTION

Accepted Solutions

UCCX Application Tasks not terminating

I'm 95% sure you'll have to restart the Engine.  I'm 5% sure these will clear out on their own, as most scripts will eventually end.  Of course, if you are receiving calls at a rate faster than these are clearing, you may end up with a java heap core dump soon.  I would just reboot to be safe.

On the other side of this coin, are you at all interested in finding out why these are hanging?  I would be curious to know.

Anthony Holloway

Please use the star ratings to help drive great content to the top of searches.

Anthony Holloway

Please use the star ratings to help drive great content to the top of searches.
3 REPLIES

UCCX Application Tasks not terminating

I'm 95% sure you'll have to restart the Engine.  I'm 5% sure these will clear out on their own, as most scripts will eventually end.  Of course, if you are receiving calls at a rate faster than these are clearing, you may end up with a java heap core dump soon.  I would just reboot to be safe.

On the other side of this coin, are you at all interested in finding out why these are hanging?  I would be curious to know.

Anthony Holloway

Please use the star ratings to help drive great content to the top of searches.

Anthony Holloway

Please use the star ratings to help drive great content to the top of searches.
New Member

UCCX Application Tasks not terminating

Yes, I am very interested in finding out why this is happening.  There must be some sort of loop in the script, or it's not terminating somewhere it should.  I'm going to go through it to see if I can see anything obvious.

New Member

UCCX Application Tasks not terminating

You were correct in that I had to restart the engine last night to clear out the sessions.  I'm also pretty confident that I found and corrected the problem.  In our script, there was a section that looked to see if our call center was open.  If not, it sent the caller to a recording stating we were closed, but it didn't go anywhere after that, so I think it just kept the session open for an indefinite amount of time.  I added a "goto end" statement after the recording, and this morning, I don't see any stuck sessions.  Thanks for your help.

416
Views
0
Helpful
3
Replies
CreatePlease to create content