Hi All, I can find the install and SRND documentation for UCCX Install but it doesn't actually tell me what is required and how it works. Basically if I have a HA environment, do I need 2 X route points and 2 X CTI ports, will I need to generate these seperatly from each UCCX serbver an hence re-install the applications and scripts and everything else twice, do I need to do a call forward no answer on the primary route point to go to the secondary one?
Oh right - think I get it. so if the route point tries to forward a call on a cti port but that cti port is unregistered because the uccx server is down it will eventually go to one of the cti ports that is registred from the secondary uccx server?
I have and UCCX in HA, but in the Call Control Group I the area that said Number Of CTI Ports I can´t fill the blank with 50 (CTI ports that I have configured in the Call Manager) after the synchronization just show
In progress.... and after to refresh the page are shown only 25 CTI ports asociated, What Could be the reason of this behaivor?
Thank you very much if some body can help me with this.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.