i need assistance to one of my script, which will call the url and capture the response. though i was able to complete the Script for sending and receiving the parameters. when i started testing of the script, i figured out that when the webserivce is shutdown at the other end, my script doesnt work and i am not able to follow the workflow to tell the caller. i found few exceptions but the only problem i m facing in it is how to capture exceptions. what parent exceptions would be used to capture the following
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...