Hi, I have imported a contact list that has two different phone numbers for a contact, how is the proper way to use the skip-next action for the system to use the second number to try to reach the contact after calling the first number and realizing that the person wasn't at home for example.
Actually I set the wrapup work to 300 seconds, but when I am in the work state I immediately press the ready state, this for not waiting for the wraupup time to end, but never dial the second number, I think I am running through the bug that you told me in the other thread the CSCsx26644, I have a UCCX 5.0(2)SR02_Build045
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...