Hi All - Few clarification in configuation of Write Policy during Installation of RAID.
We have 8 HDD with 300 GB, Out of which i confifured 2- HDD as RAID - 1 and installed ESXI - 5.0 U1 and remaining 6 HDD as RAID - 5, I would like to know which write Policy i need to choose for both RAID
Set Write Policy to one of the following:
- write back with bbu- if using a RAID card with SuperCap (e.g. RAID-9266CV)
- always write back – if using a RAID card with legacy Battery Back-Up (BBU) instead of SuperCap (e.g. RAID-9266). This option helps prevent a UC application performance impact in the event that the BBU goes into learning mode or the battery dies.
Whenever possible, use the new RAID cards with SuperCap and make sure the UCS is attached to an Uninterruptible Power Supply (UPS).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...