Has the issue regarding UICM Script Editor use on dual monitors been resolved for UICM v7.5 thru current release?
There was UICM script corruption issue in v7.5(x) when UICM Script Editor was moved over to the second screen of a dual screen system. If the edited script was saved, it was corrupted. The TAC response, at that time, was use of workstation dual monitors was not supported for v7.5(x).
CSCsq18107 was filed to update the documentation for this requirement. Customers were asked to raise a PER ( product enhancement request ) ticket for it but it seems no ticket was raised & I dont see this requirement closed in any of the versions released so far. This means, the dual-monitor is still not supported. Not sure if 9.0 comes with good news.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...