Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unable to change codec to G.729 during re-installation

Hello, i have installed G.711 codec with CRS 4.0(3). Now i want to re-install using G.729 codec but even if i can choose G.729 during the setup process, the available codec after re-installation stay G.711.

Any ideas ? Thanks in advance.

Julien.

2 REPLIES
Bronze

Re: Unable to change codec to G.729 during re-installation

It's a known defect. There's a bug for this problem.

CSCsc65438 - Unable to change codec by re-installing

New Member

Re: Unable to change codec to G.729 during re-installation

Thanks, TAC has confirmed this defect.

I had to uninstall completly, then reinstall with G.729. It's OK now.

Thanks again.

92
Views
0
Helpful
2
Replies