has anyone experience upgrading CRSs from 3.5 to 4.0(5a).
I tried it this weekend following the instructions in the Cisco Customer Response Solutions 4.0(5a) Installation Guide (Backup CRS 3.5 / Reimage Server / Install CRS 4.0(5a), Restore, Migrate)
It worked well for the first Server.
But I can't restore the second. The backup works fine and ends successful. The installation of the new CRS files complete without problem. However, if I try to restore the data from BARS the restore fails after 68% with an LDAP Error.
I made for each CRS a new LDAP Cluster Profile, perhaps this is wrong and I have to use the same profile for the first and the second server.
Or is it easier to run a new / clean set up for the second CRS.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...