Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using 'SetTransferLabel' command with H323 CVP deployment

Hi,

We have a CVP 4.1comprehensive deployment using H323.

We have coresident Ingress/VXML gateways, a gatekeeper and a CallManager cluster.

In order to reduce the transfers between Ingress and VXML gateways we are planning to use the 'SetTransferLabel' command to make calls treated in the same VXML gateway as the originating Ingress gateway.

Is there any configuration that we should do in addition to the 'SetTransferLabel' command in CVP VBAdmin?

Is there any special requirements that we need to do?

Thanks in advance.

2 REPLIES
Green

Re: Using 'SetTransferLabel' command with H323 CVP deployment

Yes there is. If the transfer label is (say) 8111111111 then when a CVP warm transfer is called, you may have the system trying to send this label back to the originator when the originator is CUCM. In order to prevent this you should add your subscribers to the list of "setExcludeIPs" (I can't recall the exact VBAdmin setting, but it's something like that. You will find it).

This is important with H.323 but not needed with SIP.

Regards,

Geoff

New Member

Re: Using 'SetTransferLabel' command with H323 CVP deployment

Thanks Geoff.

356
Views
0
Helpful
2
Replies