Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Web trigger issue

I have two servers in HA

express v7 sr1

10.0.0.1 - master

10.0.0.2 - slave

I have a web page the points to an http trigger on my ipcc express servers and passes some values

http://10.0.0.1:8080/promptmgr?CCName=1&P_No=Welcome_Msg&CC=690&Action=1

This all works fine when 10.0.0.1 is the master but if 10.0.0.2 is the master I just get a black page, in older versions the the master would fwd the request from the web page to the new master, but its not doing that now, is there a way round this?

1 REPLY
New Member

Re: Web trigger issue

Check out this bug. It might be your issue.

CSCsy58015 Bug Details

Http trigger does not work when failover occurs

Symptom:

http trigger, from where they are passing the parameters to the script. It works fine when the Node1 is mater... if it fail over to Node2 then the information is not passed to the script.

Conditions:

HA setup and if it failover to 2nd Node.

Workaround:

Make changes to asp/http file where they have the ip address of the Node1 to Node2

1st Found-In

5.0(1)SR1

7.0(1)SR1

Fixed-In

7.0(1.2.93)

Jim

145
Views
0
Helpful
1
Replies