Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Webview failed after installing ISE

After installing ISE, successfully login to Webview but can only see the frame and no menu to select report type. Any thoughts?

ICM 6.0 SR7

Tried uninstalling SR7, rerun ICM setup from media and bin but still having the same issue.

  • Contact Center
1 REPLY
New Member

Re: Webview failed after installing ISE

Pretty sure this is permissions based.

Case sensitive logins. You can login using the 'wrong' case when going into wv you just won't be able to run reports until you use the right case.

Have you also checked Jaguar is running? it was always a bit wobbly on v6.

Cheers

Bully

111
Views
0
Helpful
1
Replies
This widget could not be displayed.