May I ask why exactly you'd like to do this? Need to query CM data in your Contact Center reports?
Did you read somewhere this is possible?
By default, the appliance CM devices have a firewall up and running only allowing specific hosts. Informix DB Server trusts are enabled by .rhosts (which should contain the other hosts in the cluster) and Cluster Manager (CLM) running on the CUCM servers opening the ports for the trusted servers.
This could only work if you could add the CUIS nodes to be a trusted for the CUCM cluster. Out of the box this is not possible as far as I know.
Might be a good future request for you to raise with your Cisco account team though. I can see a use case for this.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...