I've been trying to get a demo of WFM loaded for a Contact Center Express install. But every time it finishes setup and starts the configuration wizard, it will never finish the database configuration. It errors with "could not connect to wfm database". I wiped the box and it has a fresh install of Windows 2003 and SQL 2005. Thoughts?
SQL 2005 out of the box does not allow remote access and therefore WFM wouldn't connect up. I went into the SQL Configuration Tools, then to Surface Area Configuration and enabled remote access via TCP/IP.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.