Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Cisco UCS PowerShell Configuration Script video

(view in My Videos)
The video starts with me showing an un-configured UCS cluster and then I kick off the script.

After the script completes I go back through UCSM showing all of the pools, policies and templates that the script created. The script also configures the LAN/SAN Port-Channels, VSANs, VLANs and admin settings.

The video is silent and lasts about 7 minutes

You can watch it in HD here - https://picasaweb.google.com/109824299474903453524/TechVideos

5 Comments
New Member

Thanks Jeremy

Will have to learn this as looks a great time saver as well as great way to reduce / eliminate user misconfigurations.

Regards

Colin

New Member

How about the PowerShell script? Could we get a link to that, or a template? This is interesting.

thanks!

Craig

New Member

hello,

i have a question please,

should we perform a configuration on a switch before connecting via powershell (after installing cisco-ucs powertoolkit)? especially with "connect-ucs."

because I try to connect to a switch but the connection fails.

thank you for any response.

You must perform initial Fabric Interconnect / cluster setup from the console and have IP connectivity to UCSM. I would also configure any needed FC ports if you have the 6200 series FIs because of the required rest or reboot after the ports are set to FC

480
Views
0
Helpful
5
Comments