03-01-2016 08:04 AM - edited 03-01-2019 08:12 AM
I’am a student making an apprenticeship.
My current task is to create a new VPN LAB environemente.
I have to compare DMVPN Phase 3 with Cisco LISP + GETVPN.
Thanks to the Cisco GETVPN+LISP Lab Guide I was able to build a quiet good lab.
But there is no MGMT routing separation. I want to have Loopback 0 interface and the interface facing to the RLOC to be vrf forwarding to MGMT.
But then LISP stopped working.
I was searching for a solution and I tried to vrf forwared the Lisp Interface , which did not worked out for me.
I didn't quiet get what those 2 commands are supposed to do.
Ip lisp source-locator
Ipv4 alt-vrf
Is it even possible to pop the interface facing to the RLOC into an other vrf?
Thanks for your help, I really appreciate it.
Solved! Go to Solution.
03-22-2016 01:09 PM
I am not sure I understand, do you have a topology and diagram? You can create a separate EID table called management and "client registration interface" command to source it for GETVPN, example:
crypto gdoi group management-group
identity number 2016
server address ipv4 10.255.255.1
client protocol gikev2 default
client registration interface Loopback2016
Under router lisp:
eid-table vrf management instance-id 1
The loopback2000 would have the VRF management.
You may need to change the following:
"locator-table default," This could be "management" or "default."
03-22-2016 01:09 PM
I am not sure I understand, do you have a topology and diagram? You can create a separate EID table called management and "client registration interface" command to source it for GETVPN, example:
crypto gdoi group management-group
identity number 2016
server address ipv4 10.255.255.1
client protocol gikev2 default
client registration interface Loopback2016
Under router lisp:
eid-table vrf management instance-id 1
The loopback2000 would have the VRF management.
You may need to change the following:
"locator-table default," This could be "management" or "default."
03-22-2016 02:33 PM
Hey Jaffer Razvi
I fixed the Problem by using
locator-table vrf VRF4RLOCINTERFACE
under router Lisp
Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: