06-08-2010 03:19 PM - edited 03-13-2019 07:00 PM
I am trying to get DMM software installed on an HP DL380G5 that is the equivalent build of an MCS7835. I need to get the configuration work started while I am waiting for the customer's gear to ship. The DMM software comes up and says it is not supported hardware. Does anyone know of a way to get the software to load on this server?
Solved! Go to Solution.
06-08-2010 04:42 PM
I am sorry. Software installed on an unsupported platform is not allowed.
In fact, the DMS Products such as the Digital Media Manager & Show and Share
are "appliances". The software in already installed on the server unless it is an
upgrade to a previous version.
If you have a demo version of VMware images obtained from Cisco, those images
should run fine in a VMware environment on the HP Servers.
For additional assistance, You should contact your local Cisco Account Team or
Sales Rep.
Cheers!
T.
06-10-2010 05:37 AM
Since this thread is completed, Please take time to mark this discussion answered & rate the response. Thank You! T.
06-08-2010 04:42 PM
I am sorry. Software installed on an unsupported platform is not allowed.
In fact, the DMS Products such as the Digital Media Manager & Show and Share
are "appliances". The software in already installed on the server unless it is an
upgrade to a previous version.
If you have a demo version of VMware images obtained from Cisco, those images
should run fine in a VMware environment on the HP Servers.
For additional assistance, You should contact your local Cisco Account Team or
Sales Rep.
Cheers!
T.
06-08-2010 06:23 PM
Thanks for your reply.
06-10-2010 05:37 AM
Since this thread is completed, Please take time to mark this discussion answered & rate the response. Thank You! T.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: