Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DMP 4300 Firmware Upgrade

During the firmware upgrade of a DMP 4300 from Ver. 5.0 to Ver. 5.0.2 there was a disconnection and the upload of firmware image was interrupted.

The DMP now does not boot and gives no display at all. It shows the red led indication but does not try to take an IP from DHCP.

Is there a way to resolve this issue?

Regards,

Chaitanya Datar

Everyone's tags (2)
1 REPLY
Cisco Employee

Re: DMP 4300 Firmware Upgrade

Chaitanya,

My apologies, but a power disruption or a transfer interruption during the firmware upgrade could cause a non-recoverable error on the DMP. The DMP will display the symptoms that you describe.  The only resolution is to Open a Case with the Cisco TAC and RMA the DMP.

T.

943
Views
0
Helpful
1
Replies