Re: DMP 4305 with firmware version 5.2.1 not registering with DM
I just completed this upgrade and had the same issue. If the suggestion of resetting the DMP does not work, this is what I had to do to get it working:
Problem: DMP will not connect after upgrade to DMM 5.2.1
The DMP passes the username and password for verification. If you change the password on the DMP from anything other than 'default' the DMP will not connect! This seems to be a bug with 5.2.1. The DMP password , when upgraded to 5.2, cannot be reset to 'default' because of new password restrictions. So I had to do the following:
1-Reset the DMP to 5.03 and reset to default settings
2-Close all browser windows and log into the the 5.03 DMP to make sure 'default' was the password
3-Upgrade to DMP to, in my case, 5.2.1.
4-Log in and the password should now be set to 'default'. Don't change it until the bug has been fixed!
Hope this helps or is relevant.
PS I am attaching the 5.03 Image Firmware in case you need it!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...