We have deployed 2x 4400 with DMS 5.1. We are using one of the screens to display room booking from our Peoplecube Resource Scheduler application - Displays bookings for around 10 rooms. They have a displayboard webpage called via an ASP page. The page is able to refresh the content displayed using a setting as part of the URL which is configured in seconds.
The page displays fine for around a day, when refreshed on a 10 second cycle, then locks up. I have changed the refresh rate to 2 minutes, but get the same issue after around a day. Power cycling the DMP resolves the issue, but only for another 24 hrs or so. Would this be an issue with the DMP or would this be more related to the webpage being delivered by the Peoplcube system? Just looking at where to push the issues back too, our Cisco partner or to peoplecube. Thanks for any assistance provided.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...