Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Fail DMM 5.2.3 in clustering mode

Dear all,

We have a problem when try to Activate the cluster in the Failover Configuration window.

We have upload the clustering module license & the base license in both of the servers

DMM-SVR-C210-K9

DMM-FA-C210-K9

...but when I click in the Activate button appear this error:

Sending Request

"No cluster Activaton in progress"

[Activate]: Publishing configutation to X.X.X.X failed

This is my configuration:

SRV

Set as Master: Name: DMM Cluster

Primary FQDN: bv01.test.com

Secondary: bv02.test.com

Virtual FQDN: bv.test.com

FA

Master FQDN: bv.test.com

Clustering Status: Unconfigured

Replication interface Crossover

Thanks.

1 REPLY

Fail DMM 5.2.3 in clustering mode

I find in the FAQ this:

Q: What does the error message "Unable to publish cluster configuration to node" mean?

A: The cluster configuration cannot be pushed to the specified node. The most likely cause for this is that the cluster master has not been set on that node

...But I checked the

Cluster master set to bv.test.com

in the second node and the crossover cable is correctly conected and appear the same message:

[Activate]: Publishing configuration to X.X.X.X failed

Any idea?

697
Views
0
Helpful
1
Replies