Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to turn off/on DMP via command

Hello,

I have a couple 4400 DMPs that need to be turned on and off remotely.  How can this be done via a remote command and what is the command?  These DMPs are not connected to a DMM.

Thanks,

Jason

4 REPLIES
New Member

How to turn off/on DMP via command

Try this to "RESTART" your DMP.

https://admin:default@w.x.y.z:7777/set_param?mng.reboot=1

admin= username assigned to access DMP

default= your dmp password

a.b.c.d= the IP address of your DMP

Let me know if this works. I do not have a DMP to test this on right now.

-Keith

New Member

How to turn off/on DMP via command

Thanks Keith.

I have used this command but I was wondering if it were possible to power down the DMP at say 10 PM and then start it back up at 8 AM. 

Or do the DMPs typically run all the time?

Thanks,

Jason

Bronze

How to turn off/on DMP via command

Jason,

In most of our deployments we leave the DMP on all the time but we schedule turning the monitors on and off.

John

New Member

How to turn off/on DMP via command

Jason,

4400's DMP Power consumption:

• Peak: 30W; average: 15W

Also John is correct. Scheduling down time of the LCD's would be the better "green initiative" here :-)

Hopefully your displays have the RS232 option. If so and you need a quick start see:

https://supportforums.cisco.com/message/3066692#3066692

Best Regards,

Keith

If this answers your question, Please take time to mark this

discussion answered & rate the response.

496
Views
0
Helpful
4
Replies
CreatePlease login to create content