01-18-2012 03:44 AM - edited 03-15-2019 05:20 AM
Hello Netpro,
I need your feedback on the following problem:
I have just received the CS210 servers for DMM and SNS. As soon as i boot them, i receive some messages on my screen that there is no boot media found....
The Quick Start guide for 5.3 states that :
At the "Start of First Boot" message, press Enter .
Though, this message is not visible on the screen. So now i dont know how to proceed since there is no image for 5.3 from cisco to be downloaded.
Any ideas???
01-18-2012 05:42 AM
Hi Panayiotis,
If you didn't either get the software pre-installed or the DVDs to install it, it means that most likely, the wrong part number was ordered.
Please, open a TAC case and provide the purchase order number. We'll verify whether the software was included in the order, and if so, publish the images for you.
Regards
Daniel
01-19-2012 03:10 AM
Hi Daniel,
We would do that,thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: