I need to stream a multicast video (SD) from a tv receiver over a DMS 5.2 network to the DMPs 4400G, using the SA Encoder D9022.
I've never done this before, and when I first open the Web Interface of the enconder I saw many parameters to configure, and I'm afraid not doing this right, cause video doesn't plays at the DMPs.
All NICs (TS Out and Mgmnt) are configured and can be reached by ping command.
I think I could be able to play the stream on my PC, using the browser, pointing to udp://18.104.22.168:5555 or somehow, since this is the multicas IP defined on TS Stream tab for the encoder web interface.
So, is there any document describing how to first set up this scenario (on both DMM and D9022)?
The configuration steps as follows
for the SA Encoder:
* Plug in both Ethernet connections
* Give it a management IP address
* Enable the encoder in the GUI
* Set the Bitrate for video
* Set the multicast address
That is pretty much it.
One note about bitrate. There is a bitrate in the encoder settings, that is
the actual bitrate of the video. The bitrate settings in the Tsoutput is the
budget for the video, its essentially a maximum amount of bandwidth that can
be used. It usually defaults to 10000000 (10mb/s)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...