Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Issue with Media URL display in 4305G

I can run a mpeg URL if it is posted in Media URL within DMP by clicking Start but if I try sending the same URL either through Startup URL or as a Job I get an error "Write enable the disc or try different folder."

Everyone's tags (3)
3 REPLIES
Cisco Employee

Re: Issue with Media URL display in 4305G

Pankjb,

What is the format of the Video Content?

What is the sample URL that you are using?

What DMS-DMP version are you running on the 4305G?

In 5.2,  There is a Startup "Media" & "Browser" URL.  For "video" content you need to use

the MEDIA URL.  I have tested and it works fine.

If this answers your question, Please take time to mark this

discussion answered & rate the response.


Thank You!


T.

Community Member

Re: Issue with Media URL display in 4305G

What is the format of the Video Content? MPEG.

What is the sample URL that you are using? http://10.1.10.10/test.mpeg

What DMS-DMP version are you running on the 4305G? 5.2

In 5.2,  There is a Startup "Media" & "Browser" URL.  For "video" content you need to use the MEDIA URL.  I have tested and it works fine.

Yes when I paste this url in Dispaly Actions --> Media URL and press Start works fine. But the same URL I try to submit using Go To URL it gives error "Write Protected". If I give the same as Startup URL in Media - no display.

Cisco Employee

Re: Issue with Media URL display in 4305G

Please provide screenshots of the following screens from

the DMP-DM:

* Settings->Basic

* About->Hardware and Firmware Versions

You mention:

"But the same URL I try to submit using Go To URL it gives error "Write Protected"."

There is no "Go To URL" setting where are you seeing that?

thanks


T.

653
Views
0
Helpful
3
Replies
CreatePlease to create content