I have searched and talked with many people regarding your issue , without any result. I think only people who have the answer Cisco developers for AS7100 , please find the below link which i hope help you to get your answer. Just open a case and tell Cisco your problem , after 24 hours you will get an answer. Please if you get a solution , i hope to share with us . Best of luck
The only real way to reset the Admin ID is to reimage the 7100. This can be done by attaching a keyboard and monitor to the appliance. It restores the system from a default partition a lot like a home PC recovery partition. There is a recovery menuing system before windows launch. Contact support for the instructions on what choices etc.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...