I tried to fight with google's but can't resolve a problem.
I've got Cisco swirch with IOS 15.0(2)SE4 and configured a few ports as Cisco Access Point smartports. AP's connected to that ports works only with that setting. Case is that I even can't ping AP's under its IP address. If I change the setting i.e. to Desktop I can work with AP but there is no internet connection on WiFi
Please help... I would like to monitor AP's with SNMP.
My target is to connect with Cisco Access Points with appropriate smartports settings.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...