Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

EEM on 2960S LANBASE?

Howdy all.

 

I'm hoping someone can help answer whether EEM is supported on a 2960S switch with LANBASE (not LAN Lite). I'm running 12.2(55)SE9 UNIVERSAL, which, according to Feature Navigator, supports EEM 3.2.

When I try to configure event manager on the CLI, the command is unrecognized.

I have tried this under both the default and lanbase-routing SDMs.

 

Thanks,

Justin

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

The 2960 only supports EEM

The 2960 only supports EEM-lite (to drive auto smart ports).  You will not be able to configure your own EEM policies.

4 REPLIES
Cisco Employee

The 2960 only supports EEM

The 2960 only supports EEM-lite (to drive auto smart ports).  You will not be able to configure your own EEM policies.

Good to know. Thanks Joe! I

Good to know. Thanks Joe! I was hoping the EEM guru would chime in. :)

New Member

I am not able to configure

I am not able to configure EEM script on  WS-C2960-24TC-L running c2960-lanbasek9-mz.150-2.SE7.bin.

Here is the error message. 

IND-HYF-CON-ACC-SW-0(config)#event manager
^
% Invalid input detected at '^' marker.

IND-HYF-CON-ACC-SW-0(config)#e?
eap enable end energywise
epm errdisable exception exit

IND-HYF-CON-ACC-SW-0(config)#e

Not getting option for any command like event manager. 

Cisco Employee

As already stated in this

As already stated in this thread, EEM is not supported on the 2960 series.   Only EEM-Lite is supported, and this means you cannot configure your own policies.

440
Views
5
Helpful
4
Replies