Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EEM Script not Executing Completely

Hi,

We have 50+ remote sites where we run an EEM script that shut's the main tunnel interfaces and forces the site to run on backup once a month. After 24 hours another script executes and brings the main tunnel interfaces back up.

This has been working for months at all the sites. We now have one site that appears to be having a problem in that it executes the first script shutting the interfaces and then 24 hours later it executes the second script but never actually no shut's the interfaces. 

Does anyone have any suggestions as to what I should run to log or debug to see what the problem is?

I am attaching the script from the site. The only changes between sites are the dates they run.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

You should enable "debug

You should enable "debug event manager action cli" and look at the logs after the one site has the problem.  This should tell you why.

1 REPLY
Cisco Employee

You should enable "debug

You should enable "debug event manager action cli" and look at the logs after the one site has the problem.  This should tell you why.

21
Views
0
Helpful
1
Replies